Yugo mauser m48 js full#

Yugo mauser m48 js full#

I am in no way a purist, just that I have spent lots of money on sporters, and I have one nice little scout Mauser in 7x57 and a small graveyard of bubba'd Mauser and Mosins.Д«TW here is mine, I got it in full cosmo from big 5, almost all of the blue was removed. Also you can put the rifle back to its original config. Should be good enough for minute of deer. To MLC's point, if all you have are milsurps, there is nothing wrong with a scout scope and an S&K type scout mount. One of the reasons the US has lower specs is folks have a tendency to load hot rounds in a GEW88, or hot 7x57 rounds in a Spanish Mauser and blow themselves up. The last time I checked the privi were loaded to US specs, so if you feel safer, by all means shoot those with confidence. Here is a link to some of the markings you may find So the rifle should have been tested and proofed at the time of re-arsenal. You should have seen the proof markings, the three dots for hardness and the assembly marks. I am sure you had to clean layers upon layers of cosmo from the rifle. Some folks say they were parts guns, other say they were scrubbed, and others say they are exactly as intended. Sax, the only way to test your rifle would be to be in a controlled lab and keep upping the load until it failed. I just put it back to the original config and left it at that. The rifle looked fine to me, but was very uncomfortable to shoot. I know, as I installed a JMECK non-smithing mount (designed for the mosin) and my scope sat a little lower than the zrak. Every time you shoot, it will feel like you are getting punched in the jaw. With the zrak or other scope options, the scope sits pretty darn high. Lastly, I have an M48, it is a very accurate and fun rifle to shoot. If you get the correct mounts and scope, you can then keep or sell it as a repro sniper. There is nothing like spending $600 to build a $300 rifle. Since you know about the zrak, you also know they are not cheap, so you will have to weigh the return on investment.

If you are satisfied with the accuracy, then if you were to scope it, the best would be to get the correct Zrak mounts and scope. First I would check and see how the rifle shoots before going through the trouble of scoping it.